EverflonTM FEP 4610
Tensile, Flexural and Compressive Properties of FEP
Review how temperature affects tensile strength, flexibility and compressive behavior.
Mechanical Properties
FEP products are tough, flexible in thin sections and stiffer in thick sections. Stiffness measured by flexural modulus decreases substantially with increasing temperature.
Surface friction is low, though slightly higher than PTFE. Few substances adhere readily; treatment can improve bonding with conventional industrial adhesives.
Tensile Properties
Engineering equations can support FEP part design when appropriate data and safety factors are used. Yield occurs at small deformation, with nonlinearity beginning at a few percent strain. Establish acceptable strain before determining corresponding stress.
Figure 1 covers small strains; Figures 2–5 show tensile behavior at −52°C, 23°C, 100°C and 200°C. Specimen preparation, geometry and test conditions affect results and must be consistent for comparisons.
Approximate source redraw; not measured 4610 data.
Approximate source redraw; not measured 4610 data.
Approximate source redraw; not measured 4610 data.
Approximate source redraw; not measured 4610 data.
Approximate source redraw; not measured 4610 data.
Figures 6 and 7 show temperature effects on tensile strength and elongation at break.
Approximate source redraw; not measured 4610 data.
Approximate source redraw; not measured 4610 data.
Yield strength matters in practical design. The table reports the source's temperature-dependent yield strength.
| °C | °F | MPa | psi |
|---|---|---|---|
| −251 | −420 | 165 | 24,000 |
| −196 | −320 | 131 | 19,000 |
| −129 | −200 | 97 | 14,000 |
| −73 | −100 | 62 | 9,000 |
| −56 | −68 | 28 | 4,000 |
| 0 | 32 | 14 | 2,000 |
| 23 | 73 | 12.4 | 1,800 |
| 70 | 158 | 6.9 | 1,000 |
| 121 | 250 | 3.5 | 500 |
Flexural Modulus
Flexural modulus measures stiffness. FEP remains flexible at very low temperature; stiffness decreases as temperature rises.
Approximate source redraw; not measured 4610 data.
Compressive Stress
At low strain, compression stress–strain curves resemble tensile curves. Figure 9 compares low-strain compression at three temperatures.
Approximate source redraw; not measured 4610 data.
Source data, charts and compliance statements concern another manufacturer’s reference material. Renaming a grade does not establish equivalence or measured performance for Everflon FEP 4610. Curves are approximate illustrations, not engineering input. · Product and Properties Handbook: Mechanical Properties; Tensile Properties; Flexural Modulus; Compressive Stress